IBS cable in drive, Cable Service, Connection cable for locking, Motor cable extension cord, RLG cable, Motor cable, Connectors MSTB, WAGO 2, End and intermediate plate, Adapter for light curtain, WAGO male connector, WAGO pin header, WAGO pin header, WAGO pin connector, WAGO spring strip, WAGO female connector, Miniature terminal block

BLASI – Connection cable for locking, TA-6SP

Name: BLASI - Connection cable for locking, TA-6SP - MaceGulf
SKU: BLSP-8630253

BLASI – Connection cable for locking, TA‑6SP is a dedicated low‑voltage control cable used between the BLASI TA‑6SP accumulator and the locking or electro‑lock unit in swinging or sliding‑door operators. It carries the locking control signal that enables the door to engage or release the mechanical or magnetic lock at the correct moment in the opening and closing sequence. This BLASI – Connection cable for locking, TA‑6SP is fully insulated and factory‑terminated with plugs that match the TA‑6SP and lock‑interface connectors, so it installs as a plug‑and‑play harness without splicing or custom wiring. It helps keep the locking circuit clean and reliable inside the BLASI cabinet and operator housing.

Enquire Product

Product Details

BLASI – Connection cable for locking, TA‑6SP is designed to connect the TA‑6SP accumulator and control logic to the electro‑lock or locking mechanism in BLASI automatic door and barrier systems. The cable transmits the low‑voltage ON/OFF or pulse signal that triggers the lock to release when the door starts to open and to engage again when the door closes, ensuring safe and properly timed locking behavior. It is typically short and robust, intended for fixed routing from the TA‑6SP unit to the lock coil or lock module, often through a small gland or clip inside the operator housing.

The cable is made with insulated conductors suitable for the TA‑6SP control voltage and includes strain relief and sometimes screening to protect the signal from interference and vibration. It is terminated with the correct plugs or housings that fit the TA‑6SP connector and the lock terminal block, so technicians can replace the original cable directly when damaged without rewiring either side. By using the BLASI – Connection cable for locking, TA‑6SP, maintenance teams keep the locking circuit consistent, reduce the risk of wrong wiring, and support safe, reliable door‑locking behavior in BLASI automatic entrance systems.

Article No: 8630253