BLASI – Relay 230V/50Hz
BLASI – Relay 230 V/50 Hz is a general‑purpose plug‑in or PCB‑type relay used in BLASI automatic‑door control panels, energized by the mains‑frequency 230 V AC supply. It is typically a 1‑ or 2‑pole changeover (CO) relay with contacts rated for several amps at 230–250 V, allowing it to switch auxiliary loads such as indicator circuits, small motors or interlocks under the control of BLASI safety or logic modules. The relay is wired either into a screw‑terminal base or directly on the BLASI board, depending on the design, and is intended for 50 Hz operation as per BLASI‑area mains standards. Technicians source a standard 230 V AC‑coil relay that matches the BLASI‑panel layout, wiring and footprint, treating “Relay 230 V/50 Hz” as a generic but BLASI‑compatible component for low‑voltage control circuits.
Product Details
BLASI – Relay 230 V/50 Hz serves as an interface between control signals (coming from time relays, safety boards or push‑buttons) and higher‑power auxiliary circuits in BLASI‑type swing, sliding and revolving‑door systems. When the BLASI panel supplies 230 V AC at 50 Hz to the relay coil, the contacts close or open to switch loads such as warning lights, buzzers, hold‑open devices or small auxiliary contactors, while the control‑side wiring carries only the relay‑coil current. Because BLASI lists this simply as “Relay 230 V/50 Hz” in its spare‑parts sitemap, technicians usually pick a standard 230 V AC‑coil plug‑in relay (often 8‑ or 11‑pin) with at least 1 CO contact and a current rating compatible with control‑circuit use, fitted into the corresponding BLASI‑panel DIN‑rail socket or terminal row.
This type of Blasi – relay is intended for indoor control‑cabinet environments, where it is protected from dust and moisture by the BLASI panel enclosure but exposed mainly to vibration and routine switching. Many 230 V AC‑relay products in the same family offer ratings of a few amps at 250 V with tens of thousands of electrical operations and a wide operating‑temperature range, which suits automatic‑door control‑panel use. By using BLASI – Relay 230 V/50 Hz, service staff keep the control‑logic and load‑side wiring separate, improving safety, simplifying troubleshooting and making it easy to replace or upgrade the relay without rewiring the entire BLASI control board.
Article No: 7900151
Additional information
| Brand | BLASI |
|---|
