IBS cable in drive, Cable Service, Connection cable for locking, Motor cable extension cord, RLG cable, Motor cable, Connectors MSTB, WAGO 2, End and intermediate plate, Adapter for light curtain, WAGO male connector, WAGO pin header, WAGO pin header, WAGO pin connector, WAGO spring strip, WAGO female connector, Miniature terminal block

BLASI – RLG cable TA6-S/SP/SPR

Name: BLASI - RLG cable TA6-S/SP/SPR - MaceGulf
SKU: BLSP-8630236

BLASI – RLG cable TA6‑S/SP/SPR is a factory‑assembled sensor cable used in BLASI automatic doors and barriers to connect the RLG (rotary limit gauge or position sensor) to the TA‑6/S/SP/SPR control electronics. It carries low‑voltage position and limit‑switch signals from the RLG unit back to the control board, allowing the BLASI system to monitor door travel, speed, and end‑position behavior. This BLASI – RLG cable TA6‑S/SP/SPR is fully insulated and terminated with plugs that match the RLG and TA‑6/S/SP/SPR interfaces, so it can be installed as a plug‑and‑play harness without splicing or custom wiring. It helps keep the position‑feedback circuit clean and reliable inside the operator housing.

Enquire Product

Product Details

BLASI – RLG cable TA6‑S/SP/SPR is specifically designed to route position and limit‑information between the RLG sensor and the BLASI TA‑6/S/SP/SPR control unit in underfloor or swing‑door operators. The RLG is typically mounted on the motor shaft or driven gear and generates reference signals that indicate the current position of the door leaf or barrier. The cable uses shielded, multi‑core conductors sized for low‑voltage signals, so these references reach the control board without noise or interference. The cable is relatively short and intended for fixed internal routing from the RLG housing to the TA‑6/S/SP/SPR cabinet or drive module.

The RLG cable TA6‑S/SP/SPR is factory‑terminated with the correct connectors for the RLG unit and the TA‑6/S/SP/SPR electronics, so technicians can replace the original cable directly when damaged without rewiring either side. This modular design keeps the wiring neat, reduces the risk of wrong pin assignments, and simplifies commissioning and troubleshooting. By using the correct BLASI – RLG cable TA6‑S/SP/SPR, maintenance teams ensure that the BLASI system accurately tracks door position, controls soft closing and opening curves, and maintains safe and reliable operation in automatic door and barrier installations.

Article No: 8630236