BLASI – TA-6SP Accu cable
BLASI – TA‑6SP Accu cable is a prepared power and signal cable used to connect the BLASI TA‑6SP accumulator to the control or motor unit in automatic door and barrier operators. It carries both the charging and discharge power needed for the accumulator, as well as low‑voltage control lines that monitor the accumulator’s status and readiness. This BLASI – TA‑6SP Accu cable is fully insulated, shielded where required, and factory‑terminated with plugs that match the TA‑6SP connector and the associated control or motor interface. It simplifies installation and supports reliable accumulator operation in BLASI swinging and sliding‑door systems.
Product Details
BLASI – TA‑6SP Accu cable is a dedicated connection harness specifically designed for use with the BLASI TA‑6SP accumulator in underfloor and swing‑door operators. The cable is dimensioned for the current and voltage levels of the TA‑6SP system, using robust, multi‑core conductors that safely handle both the DC power to and from the accumulator and the low‑voltage control and feedback signals. It is intended for fixed internal routing between the accumulator housing and the BLASI drive or control board, where it forms a stable, noise‑resistant link.
The TA‑6SP Accu cable is terminated with the correct plugs on each end so that it can be installed or replaced as a plug‑and‑play solution, without splicing or custom wiring. This modular design speeds up both initial commissioning and any later replacement, while reducing the risk of wiring errors or incorrect polarity at the accumulator terminals. By using the BLASI – TA‑6SP Accu cable, technicians keep the accumulator circuit tidy, improve long‑term reliability, and ensure that the BLASI emergency closing and holding functions work safely and consistently during power‑outage or fault conditions.
Article No: 8630250
Additional information
| Brand | BLASI |
|---|
